Wiring Wolf Stove Ideas

May 18th

Wolf stove – An electric cooker must be connected to an appropriate outlet of 220 volts to operate. There are two different types of outlets 220 volts commonly found in homes – the taking of three slots and four output slots. Because of this, manufacturers of stove not pre-wire stoves with one or the other outlets. You must connect the stove before installation. Fortunately, it is a quick job that only requires simple tools.

Wolf Stove Style and Design
Wolf Stove Style and Design

Loosen the screws on the corners of the cover electrical access panel wolf stove. Remove the cover and look inside. Look for a set of three screw terminals in a row, with a single screw terminal, green, found below the three. Loosen the terminal screws with a screwdriver. Loosen the clamp screw small stress relief metal at the bottom of the access panel. Insert the cable end of the power plug of the stove that has four cables through the clamp and pull the cable through so that the ends of the cables can reach the screw terminals.

12 Photos Gallery of: Wiring Wolf Stove Ideas

Image of: Wolf Stove Style and Design
Image of: Wolf Stove Plain and Fancy
Image of: Wolf Stove Kitchen Appiance
Image of: Wolf Stove in White Kitchen Theme
Image of: Wolf Stove Ideas Image
Image of: Wolf Stove Ideas for Kitchen
Image of: Wolf Stove Ideas Design
Image of: Wolf Stove for Kitchen Design
Image of: Wolf Stove Fabulous Kitchen
Image of: Wolf Stove Cabin Ideas
Image of: White Country Kitchen with Wolf Stove
Image of: Gray and White Kitchen with Wolf Stove
 

Place the end of the green wire to the green screw terminal and tighten the screw. Tighten the screw clamp strain relief. Replace the cover panel wolf stove and secure with screws.